Nokia 9210 Communicator - Selection keys

background image

Selection keys

When operating the phone, press keys one at a time. The phone keypad is not
functional when the cover of the communicator is open.

Switches the phone on and off.

Switches between profiles. See ‘Profile settings’ on page 78.

Scroll through menus, submenus or settings. If there are no active

calls, you can use the scroll keys to browse through the phone book. When a call
is active, you can adjust the volume level by pressing the scroll keys.

Tip: To call your voice

mailbox, press and hold

.

Dials a phone number and answers a call. Sends the ongoing call to

hold if pressed during a call. In the standby mode: shows the list of the most
recently dialled numbers.

Ends any active call, cancels a dialled call, or clears the display.

0...9

The number and alphabet keys.

Tip: If you have

subscribed to two phone
lines, you can switch
between them by pressing
and holding

.

Used for creating functions.

The function of these two selection keys depends on the text shown

on the bottom of the display. See Figure 14.

Note: Hold the phone as you would any other mobile phone with the antenna

pointed up and over your shoulder. Do not touch the antenna
unnecessarily when the phone is switched on. Contact with the antenna
affects call quality and may cause the phone to operate at a higher
power level than otherwise needed.

IMPORTANT! Do not switch on the phone when the use of wireless phones is

prohibited, or when it may cause interference or danger.

background image

©2001 Nokia Mobile Phones. All rights reserved.

41

Pho

n

e

To use the selection keys

Figure 14

Example: Pressing the
selection key under the text
Menu, gains access to the
menu functions.

Selection keys are the keys located right below the right and left corners of the
cover display. Commands on the display vary according to the situation and
previous selections.

Tip: A press of the

key will return the display to
stand-by mode.

Often you must confirm the selection by pressing OK. If available, you can use
Back command to return to the previous menu level without making any changes.